1. Lay out the individual pieces in the shape you require.
  2. It is important to construct the side walls first.
  3. Connect the side walls (A and B, and C and D) starting at a 90° position so the fixing pins can slide down the hinge system (FIG 1).
  4. Slowly open the 90° shape walls by flattening them along the ground (clean surface) to the angle you require (for hexagonal bed) Or they can be opened so that the panels are completely straight (FIG 2).
  5. At this stage do not hammer the pins all the way into the ground.
  6. Take the end pieces and slot them into position securing with the fixing pin, again making sure you start with a 90° corner shape.
  7. When you have assembled all the pieces together to the shape you desire, (see below), use a wooden/rubber mallet to knock the fixing pins into the ground until they are level with the top of the hinge system.

    A gentle tap on the top of the pins using a mallet and screwdriver may be required to get the pins completely flush with the panels.

    You are now ready to fill the EasyBed and enjoy growing your herbs, vegetables or flowers.