1. GET A FRESH EDGE
Cut the turf using a half-moon blade or a spade to get a nice clean face to edge against. The better it is prepared, the better it will look !
2. PLACE EVEREDGE IN POSITION
Scraping the spikes from left to right in the soil helps to seat it well. Ensure EverEdge logo is facing the front and that the new piece being installed has the male section locking into the female not visa-versa.
3. TAP EVEREDGE INTO PLACE
Using a rubber mallet or a hammer on a block of wood, drive the EverEdge into the ground until your edge is flush with the turf level.
4. LOCK EVEREDGE TOGETHER
Interlock the overlap as shown.
5. PUSH IN THE LOCKING TONGUE
When all the EverEdge is installed press in the tongue using a screwdriver. Only push to about 45Â°.
6. BEND INTO SHAPE
Using either another piece of EverEdge garden edging or a length of timber EverEdge can be bent to the required angle before installing.